Auxuro

Online training

EnergyPlan training

Heat loss is mostly arithmetic, and the arithmetic is easy to get subtly wrong. EnergyPlan builds the envelope layer by layer so the R-values, the loads and the compliance check all come off the same model.

H1 / NCCThe New Zealand and Australian energy efficiency requirements it checks against
R-valueBuilt up from each layer, not typed in as a single number
ACH₅₀Airtightness at 50 Pa, which the infiltration loss is derived from

Build the envelope first

Layers, not numbers

  • Each wall, roof and floor is assembled from its real layers: cladding, cavity, insulation, lining.
  • Thermal bridging through framing is taken off the top, which is where hand calculations usually flatter the result.

Windows carry most of it

  • Frame and glass are separate; a good unit in a bad frame performs like a bad window.
  • Orientation matters for cooling as much as R-value matters for heating.

Then the climate

  • Pick the climate zone before you read any load. Every number downstream depends on it.

Step by step

  1. Draw the planTrace the building and set the storey height. Volumes come from this.
  2. Set the climate zoneNZ H1 zones or the NCC climate zone, depending on where the job is.
  3. Assemble the constructionsBuild each wall, roof and floor from its layers and let the tool work out the R-value.
  4. Add the windowsPlace them by orientation with their frame and glazing type.
  5. Set airtightnessUse a measured ACH₅₀ if you have one, or a realistic assumption for the build quality.
  6. Read the loadsHeating and cooling loads per room and for the whole house, with the breakdown by element.
  7. Check complianceRun the H1 or NCC check and look at which element is holding you back.

Reading the result

What you seeWhat it usually meansWhere to look
Heating load much higher than similar housesGlazing area, airtightness or a missing insulation layerThe element breakdown; one line is usually carrying it
Cooling load dominated by one roomWest or north glazing without shadingThat room’s window orientation and shading
H1 fails on one elementThat construction is below the schedule minimumAdd insulation there, or move to the calculation method
Heat pump looks oversizedSized on peak load with no diversity or recovery allowanceSize on the load, then check the part-load behaviour

Where to go next